2.5 pCi/Lmedian basement test in Chester CountyPennsylvania: 2.8 pCi/L
32%at or above 4.0 pCi/L57th highest of the 65 Pennsylvania counties with enough records
$1,204median system price since 20203,012 systems
Source: PA DEP radon tests, 1986–2026; tests, not homes; not a random sample. Method.
Source: PA DEP, 3,012 systems, 2020–2026, nominal dollars, as reported by installers. Method.
Area results cannot tell you your home's level. The EPA recommends testing all homes below the third floor.
Chester County on the Piedmont
Chester County lies on the Piedmont, an old landscape of folded and faulted crystalline rock. The US Geological Survey's 1993 assessment describes Precambrian granitic gneiss running northeast across southeastern Chester County, a narrow belt of Setters Quartzite and Cockeysville Marble on its western margin, and the Peters Creek Schist, which extends northeast from southern Lancaster County and "pinches out in eastern Chester County" (USGS Open-File Report 93-292-C, p. 114). Its aerial radioactivity map shows a group of high readings "apparently associated with serpentinite and marble units" in central Chester County (p. 124).
Some Piedmont rocks of southeastern Pennsylvania stand out in the radon records. A USGS study of DEP tests from 1990–2007 found a median of 6.4 pCi/L and 63 percent of results at or above 4 pCi/L on the Peters Creek Schist (1,572 tests), and 4.1 pCi/L on the Octoraro Formation, the unit with the most tests among those with a median of 4 or more (USGS SIR 2013-5143). Across the state's crystalline Piedmont as a whole the median was 2.7 pCi/L.
Because these belts of rock are narrow, neighbouring townships, and neighbouring houses, can likely sit on very different ground.
In the north of the county, the 1993 report traces a narrow belt of Cambrian rock, the Chickies Quartzite and Harpers and Antietam Formations, across northern Chester and eastern Lancaster Counties (p. 114). Tests on the Chickies Formation had a median of 2.9 pCi/L, with 37 percent of 7,520 results at 4 or more (USGS SIR 2013-5143, table 1).
The schists weather into deep ground. According to the USGS, mica schist on the Piedmont forms deep silty to clayey loams with good drainage and moderate permeability, while phyllite, slate and mafic rock give clayey soils with low to moderate permeability (OFR 93-292-C, p. 115).
How Chester County compares
32% of basement tests in Chester County were at or above the EPA action level of 4.0 pCi/L: 5 percentage points below the Pennsylvania figure of 36%.
Chester County borders Berks, Delaware, Lancaster and Montgomery counties in Pennsylvania. 2 of them have a higher share of tests at or above 4.0 pCi/L.
Source: PA DEP radon tests, 1986–2026; tests, not homes; not a random sample. Method.
Spread of Chester County results
Source: PA DEP radon tests, 1986–2026; tests, not homes; not a random sample. Method.
Chester County results over time
Tests from 2015–2026 in Chester County had a median of 2.3 pCi/L, lower than the 2.8 pCi/L of tests from 1986–1994. It describes the records, not any one house.
Source: PA DEP radon tests, 1986–2026; tests, not homes; not a random sample. Method.
Radon mitigation cost in Chester County
The median price reported for 3,012 Chester County systems installed since 2020 is $1,204, close to the Pennsylvania median ($1,200). Half of them cost between $995 and $1,425.
Source: PA DEP, 3,012 systems, 2020–2026, nominal dollars, as reported by installers. Method.
Among 1,044 Chester County systems with a test before and after the work, the median level went from 7.3 to 1.2 pCi/L, and 94% tested below 4.0 pCi/L afterwards.
Source: PA DEP, 2020–2026; among systems with a reported post-mitigation test (1,044); not a random sample. Method.
ZIP codes in Chester County
Among Chester County ZIP codes with at least 30 tests, 19369 (Sadsburyville) has the highest share at or above 4.0 pCi/L, 92%, and 19395 (Westtown) the lowest, 16%.
Source: PA DEP radon tests, 1986–2026; tests, not homes; not a random sample. Method.
Place names: GeoNames, CC BY 4.0; borders: US Census Bureau. Method.
Area results cannot tell you your home's level. The EPA recommends testing all homes below the third floor.