9.0 → 1.1median pCi/L before and after a system
73%tested below 2.0 pCi/L after
$1,395median price, 2025
Source: Pennsylvania Department of Environmental Protection mitigation records, 2020–2026; among systems with a reported post-mitigation test (26,781 systems). Not a random sample. Method.
Source: Pennsylvania, 9,516 mitigation systems, 2025, nominal dollars, as reported by installers to the Pennsylvania Department of Environmental Protection (data retrieved from data.pa.gov, updated 2026-10-13). Method.
1. The risk the EPA describes
The EPA estimates that radon causes about 21,000 lung cancer deaths a year in the United States (EPA, A Citizen's Guide to Radon, page 2). Its guide sets out the lifetime risk at different levels for people who have never smoked and for smokers, from its 2003 risk assessment:
Source: EPA, A Citizen's Guide to Radon (2016), page 12, quoting EPA Assessment of Risks from Radon in Homes (EPA 402-R-03-003). Former smokers: the EPA notes the risk may be lower than for smokers and higher than for people who never smoked. Reproduced as published; not an estimate for any person.
The EPA also states that any radon exposure carries some risk and that it does not consider any level of radon safe (Home Buyer's and Seller's Guide, section "Interpreting Radon Test Results"). It adds that reducing radon below 2 pCi/L is difficult, and that it is never too late to reduce the risk. As the table shows, the EPA's estimated risk for smokers is many times that for people who have never smoked.
2. What a system actually achieved
The EPA says some radon reduction systems can lower levels by up to 99 percent and that even very high levels can be brought down (A Citizen's Guide to Radon, page 3). The Pennsylvania records let that be checked on real installations. Where a test was reported before and after the work, the median fell from 9.0 to 1.1 pCi/L; 95% of systems tested below 4.0 pCi/L afterwards and 73% below 2.0.
Source: Pennsylvania Department of Environmental Protection mitigation records, 2020–2026; among systems with a reported post-mitigation test (26,781 systems). Not a random sample. Method.
Two cautions come with these figures. They cover only systems with a reported test after the work, and the records do not say why the others have none. And a median describes many homes: an individual house can do better or worse, which is why the EPA recommends testing again after a system is installed and every two years after that (A Citizen's Guide to Radon, page 10).
3. What it costs
The EPA puts the cost of fixing most homes at about the same as other common home repairs, adds that the cost can vary widely, and notes that like any appliance a system has running costs (A Citizen's Guide to Radon, page 9; Home Buyer's and Seller's Guide). Pennsylvania's records give the price side in dollars: the median system reported in 2025 cost $1,395, with half between $1,181 and $1,550.
The kind of work matters. Since 2020, a standard sub-slab system had a median price of $1,250, while adding a fan to a passive pipe already in place had a median of $735. The EPA says the cost is much less if a passive system was installed during construction (A Citizen's Guide to Radon, page 9); the cost of installing the passive pipe itself is not in these records.
Source: Pennsylvania, 60,311 mitigation systems, 2020–2026, nominal dollars, as reported by installers to the Pennsylvania Department of Environmental Protection (data retrieved from data.pa.gov, updated 2026-10-13). Method.
Running costs, mainly the fan's electricity, are not in these records, so this site does not put a figure on them.
Putting it together
For a home at or above 4 pCi/L, the EPA's answer is to fix it. Between 2 and 4 pCi/L it says to consider fixing. What the Pennsylvania records add is the practical side: most systems with a reported follow-up test brought levels well under 4 pCi/L, and the typical price in 2025 was $1,395. A test of your own home is the starting point; the radon levels chart shows where a result sits, and the buyer's guide covers the case of a house you are about to buy.
Area results cannot tell you your home's level. The EPA recommends testing all homes below the third floor.
This page summarises EPA publications and Pennsylvania records; it is not medical or financial advice.